Cisco Certifications Tutorials

45 http:\\ciscocertifications.info A: clock rate 64000 (not clockrate) 105. If you have two Cisco routers connected with DTE/DCE cables, to which router would you add the command clock rate? A: DCE 106. What is the administrative distance used for in static routes? A: To rate the source's trustworthiness 107. Static routes are used for which of the following? A: Defining a path to an IP destination network. Building routing tables to remote networks. 108. What is the command syntax to set a gateway of last resort in your Cisco router? A: ip route 0.0.0.0 0.0.0.0 <gateway address> 109. Which Cisco IOS command can you use to see the routing table? A: sh ip route or sh ipx route 110. You need two subnets with 35 users each. Which subnet mask would you use on your class C network address to accomplish this? A: 255.255.255.192 111. You have 8 stations connected to separate 10 Mbps ports on a layer 2 switch. How many Mbps of bandwidth will each port have? A: 10 112. Which protocol will send a message to routers if a network outage or congestion occurs? A: ICMP 113. Which protocol is used to manage and monitor the network? A: SNMP 114. Which frame has a TYPE field to identify the upper-layer protocol? A: Ethernet_II 115. When should you use static routing instead of dynamic routing? A: When you have only a few routers and want to save bandwidth. 116. What is the command for creating an IP static route? A: ip route <destination_network_address> < subnet_mask> < default_gateway> 117. When looking at a routing table, what does the "S" identifier mean?