47
http:\\ciscocertifications.info
131.Which commands should you use to enable IGRP routing?A: router igrp 101 network 192.168.1.0 network 10.0.0.0132.What routing technique prevents the router from sending info through the same interface fromwhich it was originally received?A: Split Horizon133.On a frame relay interface Serial 0, what subinterface numbers would you use?A: 1 and 2134.What are the three types of routes that IGRP advertises?A: Interior, system and exterior routes.135.Which of the following are distance-vector protocols?A: RIP and IGRP136.Which of the following routing protocols use Autonomous Systems?A: IGRP, EIGRP, OSPF & NLSP137.Each department has its own file server and the company has an enterprise server that is sharedby all departments. What would you use to provide secure separation between two different de-partments?A: routers to provide the most secure segmentation.138.What is true about link-state networks?A: They maintain a more complex table than distance-vector based networks.139.What is convergence?A: The speed and ability of a group of internetwork devices running a specific protocol to agree onthe topology after a change takes place.140.What type of routing protocols send their entire routing table every 30 seconds?A: Distance-vector141.What is the default administrative distance of RIP?A: 120142.What is the default administrative distance for IGRP?A: 100143.You just received an output that states the CDP hold time, hardware, port ID, and local interfaceof a remote router. What was the command did you enter?