61
http:\\ciscocertifications.info
305.: Which 3 tasks are required to configure a dial-on-demand (DDR) Basic Rate Interface (BRI)connection?A: Define static routes Configure the dialer Specify interesting traffic306.Which 3 statements about Frame Relay configurations using subinterfaces are true?A: Each interface must be configured to point-to-point or multipoint.Network addresses must be removed from the physical interface.Configuration must be done is router(config-if)# mode.307.What 3 statements about common elements of the TCP/IP protocol stack are true?A: IP provides connectionless service and routing UDP provides simple connectionless service without windowing or acknowledgments TCP enables devices to send large quantities of data using windowing in a connection-orientedmanner.308.Which command to you use to start to configure an IP address on an interface?A: ip address <ip-address><subnet mask>309.What is the result of using a hierarchical addressing framework?A: increased availability of addresses.310.What is the link-state protocol in the TCP/IP protocol stack?A: OSPF311.What 3 functions are supported by connection-oriented services?A: Connection parameters are synchronized. Loss or duplication of packets can be corrected. A data communication path is established between requesting and receiving device.312.Which 2 statements a reliable connection-oriented data transfer are true?A: Recipients acknowledge receipt of data. Windows are used to control the amount of outstanding unacknowledged data segments.313.Which command would you use to enable IP RIP on the router?A: router rip network 171.61.1.0 network 10.0.0.0314.Which 3 commands are used to configure information into RAM?A: config memory config terminal Copy startup-config running-config315.Which command should come last when configuring an IP access-list?